Getting Started with the SC18IS606-EVB Evaluation Board

最終更新日時： Mar 7, 2023サポート SC18IS606-EVB: I²C to SPI Bridge Evaluation Board

このドキュメントの内容

1
Get Started
2
Get Hardware
3
Configure Hardware

Design Resources

お客様の SC18IS606-EVB: I²C to SPI Bridge Evaluation Board

このドキュメントの内容

1. Get Started

The NXP analog product development boards provide an easy-to-use platform for evaluating NXP products. The boards support a range of analog, mixed-signal and power solutions. They incorporate monolithic integrated circuits and system-in-package devices that use proven high-volume technology. NXP products offer longer battery life, a smaller form factor, reduced component counts, lower cost and improved performance in powering state-of-the-art systems.

This page will guide you through the process of setting up and using the SC18IS606-EVB evaluation board.

1.1 Kit Contents and Packing List

The SC18IS606-EVB contents include:

Assembled and tested evaluation board in an anti-static bag

完了としてマーク：1.1 Kit Contents and Packing List

1.2 Additional Requirements

External power supply
External host system with I²C controller

完了としてマーク：1.2 Additional Requirements

次へGet Hardware

2. Get Hardware

2.1 Board Features

6-pin 100 mil spacing I²C interface header (JP2)
On-board SPI EEPROM which can be directly accessed by the external I²C controller via the SC18IS606
7-pin 100 mil spacing SPI interface header (JP1) to allow other SPI devices to be connected to the evaluation board to be accessed via the SC18IS606

完了としてマーク：2.1 Board Features

2.2 Board Description

The SC18IS606-EVB evaluation board is designed to be connected to an external I²C controller via a 6-pin male (JP2) header. The SC18IS606-EVB evaluation board has a non-board SPI target serial EEPROM, which can be directly accessed by the external I²C controller via SC18IS606. The external I²C controller can write, read and program the serial EEPROM without requiring an SPI target to be connected to the board.

The 3V3 power for the SC18IS606-EVB evaluation board should be supplied via this I²C interface header as well.

The SC18IS606-EVB evaluation board also has an SPI interface header (JP1) to allow other SPI target devices to be connected to the evaluation board. These SPI target devices can be accessed directly by the I²C controller via the SC18IS606 I²C to SPI bridge.

完了としてマーク：2.2 Board Description