1. Out of the Box

The NXP analog product development boards provide an easy-to-use platform for evaluating NXP products. The boards support a range of analog, mixed-signal and power solutions. They incorporate monolithic integrated circuits and system-in-package devices that use proven high-volume technology. NXP products offer longer battery life, a smaller form factor, reduced component counts, lower cost and improved performance in powering state-of-the-art systems.

This page will guide you through the process of setting up and using the TEA2209DB1584 demo board.

1.1 Kit Contents and Packing List

The TEA2209DB1584 contents include:

Assembled and tested board in an anti-static bag

完了としてマーク：1.1 Kit Contents and Packing List

1.2 Additional Hardware

In addition to the kit contents, the following hardware is necessary or beneficial when working with this kit.

AC power source: Chroma 61504
Electronic load: Chroma 63600-2
Digital power meter: Yokogawa WT210

完了としてマーク：1.2 Additional Hardware

次へPlug It In

2. Plug It In

2.1 Board Features

Elimination of forward conduction losses of the diode rectifier bridge
Very low IC power consumption (2 mW)
Integrated high-voltage level shifters
Directly drives four rectifier MOSFETs
Very low external part count
Integrated X-capacitor discharge (2 mA)
Self-supplying
Full-wave drive improving total harmonic distortion (THD)
Undervoltage lockout (UVLO) for high-side and low-side drivers
Drain-source overvoltage protection for all external power MOSFETs
Gate pull-down currents at start-up for all external power MOSFETs
Disable function for all external power FETs

完了としてマーク：2.1 Board Features

2.2 Board Components

The TEA2209DB1584 demo board consists of the TEA2209T in an SO16 package with four MOSFETs (600 V; 28 mΩ). The following figure shows the front side of demo board.

完了としてマーク：2.2 Board Components

前へOut of the Box

次へConfigure Hardware

3. Configure Hardware

3.1 Configure the Hardware

The TEA2209DB1584 demo board contains four 600 V/28 mΩ MOSFETs. It makes the board suitable for universal AC input and output power applications of several hundreds of Watts. The TEA2209DB1584 demo board contains four leads that can easily replace a traditional diode bridge. The outer two leads are connected to positive and negative rectified voltages. The inner two leads are connected to AC mains lines. These four leads are pin-to-pin with typical bridge rectifier diodes pins.

The following figure shows the difference between bridge diodes and active bridge configurations.